Table of Contents
Advertisement
WAN Port Setup
The WAN Port Setup dialog box controls how each WAN port is configured. If a port is configured for
point-to-point operation, then the mode can be either synchronous or asynchronous. If the mode is
asynchronous, then the connection method can be either Answering or Dialing. If the connection
method is dialing, then a number to be dialed has to be entered in the Dial Number field and the
correct modem type designated in the Modem Types field.
If the PPP/SLIP mode is selected, the RASFinder is configured for point-to-point operation in which
data packets are transferred between two end points. Enabling this device driver allows for either an
asynchronous or synchronous device to be connected between the end points. If an asynchronous
device is used, the RASFinder can be used as a single port remote access server. When the PPP/
SLIP mode is selected, further configuration is required using the PPP/SLIP button on the Router
Setup window.
MTASR3-200
Chapter 4 - MultiRouter Software
33
Advertisement
Table of Contents
