Table of Contents
Advertisement
RASFinder User Guide
Command:
\G n
Modem Port Flow Control
n = 0
Values:
Default:
0
Description: \G0
Returns an OK for backward compatibility with some software.
\G1
Not supported—responds ERROR.
\J n
Command:
Data Buffer Control
Values:
n = 0
Default:
0
Description: \J0
Enable data buffer—serial port speed is independent of connect speed.
\J1
Not supported—responds ERROR.
Command:
\K n
Set Break Control
n = 5
Values:
Default:
5
Description: \K5
Modem sends break signal received from the DTE to the remote modem.
Command:
\N n
Error Correction Mode Selection
Values:
n = 0–5, or 7
Default:
3
Description: \N0
Non-error correction mode with data buffering (same as &Q6 ).
\N1
Direct mode.
\N2
MNP reliable mode.
\N3
V.42/MNP auto-reliable mode.
\N4
V.42 reliable mode.
V.42, MNP, or non-error correction (same as \N3 ).
\N5
\N7
V.42, MNP, or non-error correction (same as \N3 ).
Command:
\Q n
Local Flow Control Selection
Values:
n = 0, 1, or 3
Default:
3
Description: \Q0
Disable flow control (same as &K0 ).
\Q1
XON/XOFF software flow control (same as &K4 ).
\Q2
CTS-only flow control. Not supported—responds ERROR.
\Q3
RTS/CTS hardware flow control (same as &K3 ).
Command:
\T n
Inactivity Timer
n = 0–255
Values:
Default:
n/a
Description: \Tn
Inactivity timer setting contingent on either \T value or S-Register S30 value (e.g.,
AT\T45&W0<cr> configures in parallel ATS30=45&W0<cr>), and vice versa.
Command:
\V n
Protocol Result Code
Values:
n = 0 or 1
Default:
1
Description: \V0
Disable protocol result code appended to DCE speed.
\V1
Enable protocol result code appended to DCE speed.
Command:
\X n
XON/XOFF Pass-Through
Values:
n = 0 or 1
Defaults:
0
Description: \X0
Respond to and discard XON/XOFF characters.
\X1
Not supported—responds ERROR.
Command:
-C n
Data Calling Tone
Values:
n = 0 or 1
Defaults:
0
Description: -C0
Disable V.25 data calling tone.
-C1
Enable V.25 data calling tone.
66
MTASR3-200
Advertisement
Table of Contents
