Snom M200 SC How To Set Up

How to setup a M200 SC - DECT Base
Index:
Basics
Configure M200 SC manually
Configuring the M200 SC via Provisioning
Connecting a handset
Pairing handsets
Rename Handset
Server connection
Setting up accounts
Assign account to handset
Please check in advance that your phone has the
Basics
There are two ways to set up your Snom device, manually or via "
PBX and the also quite common way is via our "
In this section, we will look at the manual way.
Configure M200 SC manually
Enter Snom Webinterface
To set up the M200 SC manually, you first need to open the web interface in a browser and log in with the default credentials.
To access the base, enter the IP address of the base into your internet browser (e.g.
instructions on how to do this in the following article:
Connecting a handset
Read below:
Setup a Server Connection
Read below:
Configuring the M200 SC via Provisioning
SRAPS
You can read instructions on how to configure a device via SRAPS in the following article:
When using SRAPS provisioning M200 device require minimum configuration otherwise config will not be accepted.
Required fields:
latest stable firmware
SRAPS " server.
Connecting a handset
Server connection
Display name
Enable SIP account
Primary SIP server address
SIP account label
SIP authentication access password
SIP authentication name
SIP registration server address
version installed.
provisioning ". Provisioning offers different ways, the most common of which is via the
click here.
http://192.168.1.100 ). You will find detailed
Endpoint Management - Phones