Locking; Centre Lift Lock (Only With R2W & R2F); Internal Waist High Slide Bolt (R2I) - B&D Roll-A-Door 2 Series Installation Instructions Manual

Roll-A-Door Series 2 installation instructions
®
WARNING! For all doors that are fitted with openers. To reduce the risk of damage to
persons or property, be sure to cut off any excess thread of the screw that protrudes
the weight bottle and file any burs.
8
WITH HANDLE

2.6 locking

2.6.1 centre lift lock (only with R2W & R2F)
a) Fit faceplate to outside of door. Fit hooks onto edge
of aperture then slide faceplate as far to the right as
possible. Use adhesive tape to hold in position Fig
2.6.1.
b) Attach the lock body to the faceplate from the inside,
using screws supplied. Do not overtighten the screws.
c) Pull the curtain down slowly into the guides below the
head stop.
d) Assemble locking bar to retainer and through plastic
edge retainer. Mark the position of lock bar on side
of guide. Transfer location mark to inside back face
of guide and drill a file slot 10mm wide x 25mm
long. Equally spaced on centre line of guide. Allow
approximately 5mm clearance from top of slot to top
of locking bar.
e) Slide bars through guide slot, then back onto lock
arms. Screw on securely using 4mm x 6mm screws
supplied.

2.6.2 internal waist high slide bolt (R2I)

(left hand side shown – viewed from inside)
With door fully closed check that bolt slides through
guide. Adjust hole if necessary.
5
6
8
7
adhesive lock
cutouts
Fig: 2.6.1
6
5
7
WITHOUT HANDLE
attach self
bar retainers this end first
(a) faceplate
(d)
(c) locking bar
Fig: 2.6.2
12
hooks
(b) lock body
(e) lock arm