Advertisement
Quick Links
©2019
All Rights Reserved. Reproduction
is prohibited without permission.
Revision date: 06.21.19
ClearSpan
Raised Bed Kits
Photo may show a different but similar model.
™
STK#
DIMENSIONS
106457
4' W x 8' L
106458
4' W x 16' L
106459
4' W x 24' L
106460
4' W x 8' L
106461
4' W x 16' L
106462
4' W x 24' L
106463
4' W x 8' L
106464
4' W x 16' L
106465
4' W x 24' L
RAISED BED KITS
TIERS
1
1
1
2
2
2
3
3
3
1
Advertisement
Related Manuals for FarmTek Growers Supply ClearSpan 106457
Summary of Contents for FarmTek Growers Supply ClearSpan 106457
- Page 1 RAISED BED KITS ClearSpan ™ Raised Bed Kits Photo may show a different but similar model. STK# DIMENSIONS TIERS 106457 4' W x 8' L 106458 4' W x 16' L 106459 4' W x 24' L 106460 4' W x 8' L 106461 4' W x 16' L 106462...
-
Page 2: Safety Precautions
RAISED BED KITS UNPACK AND IDENTIFY PARTS READ THIS DOCUMENT BEFORE YOU BEGIN The following steps will ensure that you have all the Thank you for purchasing this raised bed kit. These necessary parts before you begin to assemble the raised instructions include helpful hints and important information bed kit. - Page 3 RAISED BED KITS SQUARE THE BED Squaring the raised bed applies to designs that have four (4) right angles (90°). For designs consisting of variable angles, use an angle-measuring instrument (if possible) to verify that angles opposite each other are the same. 1.
- Page 4 RAISED BED KITS ASSEMBLE BED KIT COMPONENTS After identifying the parts included with the shipment, assemble the bed kit using the general steps below. NOTE: The shapes of raised beds vary and depend on overall design and preference. These instructions describe assembling bed kits as 4' x 8', 4' x 16', or 4' x 24' rectangles.
- Page 5 RAISED BED KITS ASSEMBLING THE BED KIT COMPONENTS (CONTINUED) 7. Layout and adjust your design. Align boards so brackets interlock as shown. If applicable, square the bed kit. Consult the Squaring the Bed instructions presented earlier. 8. Once desired layout is achieved, boards are level, and raised bed is square, slide stakes through the holes in the interlocked brackets and drive into ground until tops are level with the composite boards.