Advertisement
Assembly Instructions
ADV5 Adventus adaptor bar Universal
__________________________________________________________________________________
Now tighten the screws that sits in the clamp of the adaptor bar. Slightly tighten all four
screws on the clamp. It is important to not completely tighten each screw, but to slowly
tighten all four, a little at a time. Keep tightening until all four screws are secured (30-35Nm
of torque). Also make sure one last time that the fork is centered and the angle of the
adjustment tool is still correct.
Check one last time that all screws are properly secured. Now see the user manual of
Adventus to continue the installation. This can be downloaded from
www.decon.se/en/
__________________________________________________________________________________
Sida 9/10
Advertisement
