Advertisement
Assembly Instructions
ADV5 Adventus adaptor bar Universal
__________________________________________________________________________________
Mount the adaptorbar (A) into the holders and lock it into place using the QR Pins (D). Now
tighten the screws sitting in the clamps that connects to the frame of the wheelchair.
After the screws are tightened check that the adaptor bar still can be removed from its
holders without excessive force. If the adaptor bar is stuck in its holders loosen the screws
on one side and adjust the position.
The screws holding the clamps (G) shall be tightened to:
7-9Nm of torque (M6)
10-15Nm of torque (M8)
Loctite 243 or eq. must be applied if washers are not used.
__________________________________________________________________________________
Sida 5/10
Advertisement
