Beko BGMPI 090 User Manual page 44

5 Installation
CAUTION! After confirmation of the above
conditions, follow these guidelines when
performing wiring:
• Always have an individual power circuit
specifically for the air conditioner. Always follow
the circuit diagram posted on the inside of the
control cover.
• Screws fastening the wiring in the casing of
electrical settings may come loose during
transporation. Because loose screws may cause
wire burn-ou, check that the screws are tightly
fastened.
• Check the specifications for the power source.
• Confirm that electrical capacity is suffcient.
• Confirm that starting voltage is maintained
at more than 90 percent of the rated voltage
marked on the name plate.
• Confirm that the cable thickness is as specified
in the power source specifications.
• Always install an earth leakage circuit breaker in
wet or moist areas.
• The following can be caused by a drop in voltage:
vibration of a magnetic switch, damaging the
contact point, broken fuses, and disturbance of
normal functioning.
• Disconnection from a power supply must be
incorporated into the fixed wiring. It must have
an air gap contact separation of at least 3mm in
each active (phase) conductors.
• Before accessing terminals, all supply circuits
must be disconnected.
44 / 124 EN
To satisfy the EMC compulsory
regulations, which is required
by the international standard
CISPR 14-1:2005/A2:2011 in
specific countries or districts
,please make sure you apply
C
the correct magnetic rings on
your equipment according to the
wiring diagram that adhere to the
your equipment. Please contact
your distributor or installer to
get further information and
purchase magnetic rings (The
supplier of magnetic ring is TDK
(model ZCAT3035-1330) or
similar).
Multi Split Type Air Conditioner / User Manual