Verification Of Upgrade Installation - HP Integrity rx4640 Upgrade Manual

Verification of Upgrade Installation

After completing the upgrade, verify that the sever is ready for operation as follows:
Step 1. Reconnect AC power to rear panel connectors.
Step 2. Press the front panel power switch to power on the server.
Step 3. Wait for completion of the power-on-self-test. Verify that no errors have been detected.
Step 4. At the EFI/OS selection, select the EFI shell and enter the Info CPU command. Verify that all
newly installed processors are recognized and are responding correctly.
PROCESSOR MODULE INFORMATION
# of
CPU Logical
Slot CPUs
---- -------
0
Note 2 CPUs' per CPU slot
Step 5. Initiate the OS and monitor operation. Check for error messages. Check the System Event Log for
erroneous system events
Chapter 3
Upgrade Procedures for 1.5 GHz (A9731A) or 1.6 GHz (A9732A, or A9733A) Processors
L3
Cache
Speed Size
-------- ------
2 1.5 GHz 4 MB
^
L4 Family/
Cache Model
Size (hex.) Rev
------ ------- ---
None 1F/01 B1
Processor
State
------------
Active
Introduction
49