Advertisement
TIPS FOR USERS
1) Check the point of reference often when carrying out critical/serious
levelling jobs or press ZERO often at the point of reference. (CAL is not
necessary for levelling!) Hold the height differences between line, basic
unit and measuring module as low as possible.
2) If possible, avoid high differences in temperature between line and
measuring module (e.g. sun and shade).
3) Avoid pulling hard, whipping or stepping on the line without checking
the point of reference or setting to zero.
4) The display blinks '8888' at use beyond the specified altitude range.
Beyond the temperature range under -30 °C or over +70 °C 'CAL' is
continuously shown.
5) As the ZipLevel shows the last carried out function when switched on,
please make sure that you leave the function after every measuring.
Hold the relevant key for 2 seconds and you leave the function.
6) In muddy environments, please wipe the measuring lead with a piece
of cloth before rolling it up.
7) Does --0-- respectively „CAL" show up, press the ZERO-key as soon as
possible respectively calibrate the appliance.
MEANING OF THE SOUNDS:
- -
2 brief beeps in a row
- - -
steady sequence of beeps
___
long confirmation beep
18
GB
... Measurement display stable
... Measurement in progress
... Measurement complete
Advertisement
