Advertisement
Quick start of the ZipLevel
Open the bottom protective cap of the basic unit and remove the
measuring module. Lay the basic unit on the floor with the back facing
down. Slowly pull a sufficient length of line off the cable reel. The altitude
will be transferred from the basic unit to the measuring module.
Switch the measuring module on with the ON/OFF-key and put the unit
with its back or base on the required place of reference. When the display
is ready, you will hear 2 short audible bleeps. Press the ZERO-key for
2 seconds. Keep the measuring module steady until the figure zero
appears on the display. The appliance has now been set.
!
If the basic unit gets moved, the measuring module needs to be
set at the place of reference again.
Back facing
down!
ZipLevel Plus 30
Base
Back
05
GB
Advertisement
