Advertisement
Quick start of the ZipLevel
Give a place of reference to the measuring module (press ZERO-key) and
move it to a different height. The appliance shows the difference in height
between the place of reference and the measuring point. Now you can
hold the appliance against any point and it always shows you the current
height towards the place of reference.
Always use the measuring module with the side, which was used to set
ZERO. Do not change from one locating side to another without setting
to ZERO again.
If you want to find out the height between floor and ceiling set the
appliance to ZERO with its back or bottom side on the floor. Then hold
the top, base or back to the ceiling in order to measure. Manually add
the height (8,8 cm) or thickness (5,0 cm) of the measuring module to
the shown data.
Make sure that the device is set to „boot off". For more information,
see chapter „Boot on" / „Boot off" (page 13).
06
GB
measuring point
reference point
Advertisement
