Table of Contents
Advertisement
Filter Cleaning
IMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEANING OF THE RANGE HOOD
WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY.
Oil Collector
When the oil reaches maximum marked position on oil collector, clear the oil
in time in case of overflow. As Fig. 2-1, pull out the oil collector horizontally
to remove it.
Filter Cleaning
•
Remove the screws to remove the filter. (Fig 2-2)
•
Use warm water with detergent to steep the filter for some time later,
use rag to scrub the filter. Then rinse it again by clean water.
•
Clean filter surface after every use. Clean filter internal every week.
Fan Cleaning
•
Remove oil collector. Remove screws. Then remove main body from the
hanging bracket.
•
Remove screws from the body back to remove the chimney. (Fig. 2-3)
•
Remove the main body cover. Remove the air collector. Clockwisely rotate
tighten nut, remove the fan. (Fig. 2-5)
•
During fan cleaning, do not impact or throw away balance weight clamps
in case of reflect the fan dynamic balance to cause unit vibration and higher
noise level.
•
Clean the fan every three month.
8
Fig. 2-I
Fig. 2-2
Fig. 2-3
Fig. 2-4
Fig. 2-5
Advertisement
Table of Contents
