PAC R6000S Operation Manual page 16

R6000S Operation Manual: Rev. G
ASSUMPTIONS
The R6000S is generally installed onsite by a trained service technician. However, on occasion, it may
be necessary to move the hardware or reinstall the software, if applicable. The hardware and software
installations require the following for many PAC products; your product may differ in general needs:

Familiarity with the installation components, such as cabling, stainless steel or copper tubing for gas
lines, connectors, and fittings

An apparatus with ability to lift and transport at least the weight of the product(s)

A working knowledge of computers and associated equipment (keyboard, mouse, and monitor)

An understanding of scientific benchmarks for contaminates

A knowledge of storage, handling, and use of specialty gases, such as argon, oxygen, helium, and
hydrogen
INSPECTION
This instrument was thoroughly inspected and carefully packed before leaving our factory. Responsibility
for its safe delivery was assumed by the carrier upon acceptance of the shipment. Claims for loss or
damage sustained in transit must be made to the carrier by the recipient as follows.
VISIBLE LOSS OR DAMAGE
Note any external evidence of loss or damage on the freight bill or express receipt, and have it signed by
the carrier's agent. Failure to adequately describe such external evidence of loss or damage may result in
the carrier's refusing to honor your damage claim. The form required to file such a claim will be supplied
by the carrier.
CONCEALED LOSS OR DAMAGE
Concealed loss or damage means loss or damage which becomes apparent when the merchandise is
unpacked and inspected. Should concealed loss or damage occur, make a written request for inspection
by the carrier's agent within 15 days of the delivery date, then file a claim with the carrier since the
damage is the carrier's responsibility.
By following these instructions carefully, we guarantee our full support of your claim to be compensated
for loss from shipping damage.
NOTE: When shipping the R6000S, remove all samples and accessories from the R6000S, remove and
clean any glass jars, remove any loose deposits from ovens, lids, exhaust tubes or other parts or
sections.
DO NOT - for any reason - return the instrument without first obtaining authorization. In any
correspondence to PAC, please supply the nameplate data, including catalog number and serial number.
The nameplate is located on the rear of the instrument housing.
Page 14 of 92 PAC L.P., All Rights Reserved, 2015