Specifications; Generator; Engine - Generac Power Systems EcoGen 15 kW Owner's Manual

General Information

Specifications

Generator

Model
Rated voltage
Rated maximum load current (amps) at rated
voltage with LP*
Main line circuit breaker (generator disconnect)
Phase
Rated AC frequency
Battery requirement
(field supplied)
Enclosure
Weight (lb/kg) (without battery)
Normal operating range
These generators are rated in accordance with UL 2200, Safety Standard for Stationary Engine Generator Assemblies, and CSA-C22.2 No. 100-04
Standard for Motors and Generators.
* Natural gas ratings will depend on specific fuel joules/BTU content. Typical derates are between 10-20% off the LP gas rating.

Engine

Model
Engine type
Number of cylinders
Displacement
Valve clearance
Cylinder block
Recommended spark plug
Spark plug gap
Starter
Oil capacity including filter
Recommended oil filter
Recommended air filter
Engine power is subject to and limited by such factors as fuel BTU/joules, ambient temperature, and altitude. Engine power decreases approximately
3.5% for each 1000 ft (304.8 m) above sea level, and will also decrease about 1% for each 10 °F (6 °C) above 60 °F (15 °C) ambient temperature.
A detailed specification sheet for the particular generator is available from an IASD.
10
12 volts, Group 26R-540CCA Minimum
or Group 35AGM-650CCA Minimum
(see
This unit is tested in accordance to UL 2200 standards with an operat-
ing temperature of -20 °F (-29 °C) to 122 °F (50 °C). When operated
above 77 °F (25 °C) there may be a decrease in engine power. See
.
Specifications
G-Force™ 1000 Series
0.002–0.004 in (0.05–0.1 mm)
Aluminum with cast iron sleeve
0G0767A (RC12YC or equivalent)
0.040 in (1.02 mm)
Approximately 3.75 qt (3.55 L)
Owner's Manual for 60 Hz EcoGen™ Generators
15 kW EcoGen
240
62.5
70 Amp
1
60 Hz
)
Replacement Parts
Aluminum
460 (209)
15 kW EcoGen
2
999 cc
12 VDC
Part #070185E
Part #0J8478