Roland TrueVIS SG3-540 User Manual page 47

Setup of New Media
MEMO
This message may appear when media with high reflectance is set up.
(1)
Tap [OK].
(2)
Tap [Change].
The [Set the right edge of the printing area within the area specified by the pinch roll-
ers.] window appears.
(3)
Hold down
(B) from the left edge of the right pinch roller.
(4)
Tap [OK].
The [Set the left edge of the printing area within the area specified by the pinch rollers.]
window appears.
(5)
Hold down
(B) from the right edge of the left pinch roller.
(6)
Tap [OK].
The set left and right positions are applied to the [Printing Area (Width)].
(7)
Tap [OK].
46
Basic Operations
to move the center of the blade (A) approximately 2 mm (0.08 in.) to the inside
to move the center of the blade (A) approximately 2 mm (0.08 in.) to the inside