Conditions Of Acceptability; Warning-Explosion Hazard/Avertissement - Risque D'explosion - Honeywell MIWI350 Installation And Operation Manual

1 About MIWI350
It is approved for use in hazardous areas Class I, Division 2\Class1 Zone2. Different versions of MIWI350
are available depending on the operating temperature conditions. The permitted operating conditions are
marked on each product. Check the operating condition limits of MIWI350 before installing. You must be
familiar and comply with current applicable electrical installation standards and regulations before
installing and operating MIWI350 in hazardous areas.

1.5.2 Conditions of Acceptability

1. The MIWI350 enclosure shall not be opened in the presence of ignitable concentration of explosive
gas atmosphere. Do not connect/disconnect the device unless the power has been switched off or
the area is deemed to be non-hazardous.
2. For externally powered configurations, power to this equipment must be supplied by a source that
is categorized as "CLASS 2" and "SELV" as specified in the Canadian Electrical Code, C22.1 and
the National Electrical Code NFPA 70.
3. Use only Honeywell approved battery/battery packs with this product. Substitution of components
will void suitability for Class I Division 2.
Warning: Denotes an explosion hazard. Ensure you follow all instructions described in the warning
notification.

1.5.3 Warning-Explosion Hazard/Avertissement - Risque d'explosion

Do not Open, Disconnect, or Service in an area where an explosive atmosphere may be present. Any
service or repair shall be performed by qualified technicians only.
Ne pas ouvrir, déconnecter ou entretenir dans une zone où une atmosphère explosive peut être présente.
Toute réparation ou réparation ne doit être effectuée que par des techniciens qualifiés.
Honeywell recommends you to observe the warning information described in this document and other
generally applicable safety rules.
• No warranty claims can be asserted if there is an unauthorized interference with the device.
• You can use MIWI350 in hazardous areas, under permitted operating conditions. Ensure to
comply with the applicable laws and regulations, and company policies for the usage of
MIWI350.
• Installation, commissioning, service, maintenance, and troubleshooting of MIWI350 in
hazardous areas must only be done by specially trained and qualified staff.
• Operate MIWI350 only if the instrument is completely intact.
Warning: (For mains configuration only) This unit must be isolated or disconnected from the mains
supply before opening the enclosure. Cet appareil doit être isolé ou déconnecté de l'alimentation
secteur avant d'ouvrir le boîtier (pour la configuration secteur uniquement).
|8