Configuring Your Procare Monitor; Unpacking And Preparation For Installation; Set The Date And The Clock - GE DINAMAP ProCare 100 Service Manual

4.2 Configuring Your ProCare Monitor

4.2.1 Unpacking and Preparation for Installation

4.2.2 Set the Date and the Clock

4-4
Calibration & Maintenance: 4.2 Configuring Your ProCare Monitor
1.Unpack and identify the contents of all shipping materials.
2.Remove the ProCare monitor.
3.Unpack the external DC Power Input.
4.Insert the external DC Power Input connector into the DC input on the
lower right side of the monitor.
5.Plug the DC Power Input transformer into a Hospital Grounded AC
receptacle. The word CHARGING will illuminate green on the front of the
monitor indicating that an external power source is available.
Prior to usage, it is necessary to charge the monitor for 12 hours.
Setting the Date and Time
To set the date and time on the ProCare Monitor, you must first access the
configuration mode. The following table illustrates the menus and the
corresponding LCD display graphics.
SpO Averaging
2
SpO
2
Temp Unit of Measure
Year
Month
Day
Hour
Minute
Procedures
1. With the Monitor off, press and hold the Menu button at the same time as
pressing the On/Off button for 3 seconds.
ProCare Patient Monitor Service Manual
2009381-001
Setting Window
Pulse Rate and SpO
Temperature
Systolic
MAP/Cuff
Diastolic
min
min
Text in Window
2
Revision A