How To Remote The Control Panel - Lochinvar AMICUS HT Series Installation, Commissioning And Service Manual

5.2.2 Key function
T2:
PROBES
PROBES
PROBES
PROBES
T3:
PROBES
SET
PROBES
SET
T4:
SET
SET
ALARM
ALARM
ALARM
T5:
ALARM
PROBES
SET
SERVICE
SET
SERVICE
SERVICE
SERVICE
T6:
ALARM
CIRC
ALARM
CIRC
CIRC
CIRC
SET
T7:
SERVICE EXIT
SERVICE EXIT
EXIT
EXIT
ALARM
CIRC
T8:
CIRC
SERVICE
EXIT
EXIT
When the unit is turned on, the display will be as follows:
CIRC
EXIT
5.3 How to remote the control
5.3.2 Remote keyboard connection (VGI890)
Special care must be taken when connecting the keyboard to the Ichill200D, to avoid irreparable damage to the controller
or/and keyboard
• In case of power supply failure (wire black or red), the keyboard doesn't work.
• In case of comunication problems, the display shows "noL" message.
Allows to read the value of the probes configured
Allows to switch on the unit in cooling mode
Allows to read and modify the set point
Allows to read and reset the alarms
Allows to switch on the unit in heating mode
Allows to enter the SERVICE menù
Allows to read the main information of the circuits (compressor status, water pump status, pressure probe
value,...)
Stand-by Stand-by
Evaporator inlet temperature
Evaporator outlet temperature
External air temp. (FC)
San. water temperature
PROBES
T1
T2
Rosso / Red
Nero / Black
Bianco / White
00:00 01/01/2014
30.0 °C
35.0 °C
°C
5.0
50.0 °C
SET ALARM SERVICE CIRC.
T7
T3 T6
T4 T5
Nero / Black
Bianco / White
Rosso / Red
41
T8
ENTER
Rev. A 11-2020