Installation Of Rubber Vibration Dampers (Kavg); Serial Interface Card Rs485 (Inse) - Lochinvar AMICUS HT Series Installation, Commissioning And Service Manual

4.9 Installation of rubber vibration dampers (KAVG)

All units should be installed on vibration dampers in order to prevent the transmission of vibration to the supporting surface and reduce the
noise level. Rubber vibration dampers are available as an option in the catalogue. The vibration dampers (optional) are supplied by the
factory in separate packaging.
Mod. A
252÷312
88 mm
432÷602 88 mm
752÷1202 88 mm

4.10 Serial interface card RS485 (INSE)

Supervision system interface (MODBUS RS485 available only)
This system allows you to remotely monitor all parameters of the unit and change their values.
It is necessary to respect the polarity of the wiring as shown in the diagram. Any reversal of polarity will result in the non-functioning unit.
The supervision connectivity cable must be telephone one type 2x0, 25 mm
The unit is configured at the factory with serial address 1. In case of using the MODBUS system, you can request the list of variables by
contacting the assistance.
sez A - A
N
A
B C D
52 mm 41 mm 25 mm
52 mm 41 mm 25 mm
52 mm 41 mm 25 mm
ØM
ØD
H
B
C
G
1
L
A
F
ØE
F
A
A
E F G
11 mm 67 mm 10 mm
11 mm 67 mm 10 mm
11 mm 67 mm 10 mm
.
2
24
H L M
M12 65 mm 74,5 mm 5,5 mm
M12 65 mm 74,5 mm 5,5 mm
M12 65 mm 74,5 mm 5,5 mm
Rev. A 11-2020
N