Table of Contents
Advertisement
4.1.2 Removal of conditioning reinforcements
4.1.3 Removing transport locks 1
Unscrew all bolts using a suitable wrench until they turn freely.
2
Remove the security screws by gently turning them.
3
Place the plastic covers, provided in the bag containing the user
manual, over the openings on the back of the panel.
AT
CAUTION :
Otherwise, the machine will be damaged.
VS
Save the safety screws carefully so that you can reuse them in case you need to transport
the washing machine later.
Install the shipping safety bolts in the reverse order of the disassembly procedure.
Never move the device without the transportation safety screws being
correctly fastened!
4.1.4 Connecting the water supply
VS
The water pressure required at the inlet to operate the machine must be between 1 and 10
bar (0.1 – 1 MPa). It is necessary to have 10 – 80 liters of water from the wide open tap in
one minute, so that your machine works without problems. Attach a pressure reducer if the
water pressure is greater.
AT
CAUTION :
This type of connection will damage the laundry or the product will go into protection mode
and not work.
CAUTION :
stain your laundry.
9 / EN
Tilt the machine backwards to remove the packaging
reinforcement. Remove the packaging backing by
pulling on the tape. Do not perform this operation
yourself.
Remove the transport safety bolts before operating the washing machine!
Models with a single water inlet should not be connected to the hot water tap.
Do not use old inlet hoses on your new product. They could
Washing machine / User manual
Advertisement
Table of Contents
