Beko WTV8716XBWST User Manual page 39

5
Diagnostic
Problem
The programs do not
can't start
after closing the
loading door.
Unable to launch
or select the
program.
Water inside the
machine.
The machine does not suck up
water.
The machine does not drain
the water.
The machine vibrates or
makes noises.
Water is leaking from the bottom of
the machine.
The machine stopped
right after starting the
program.
The machine drains
the water it takes
directly.
No water is visible in
the machine during
washing.
39 / EN
cause
You have not pressed the Start/Pause/
Cancel button.
In case of excessive loading, it will be
difficult for you to close the loading door.
The machine has gone into safety mode
due to problems with the power supply
(circuit voltage, water pressure, etc.).
There may be water left in your machine as a
result of quality assurance processes carried
out during production.
The tap is closed.
The water inlet hose is bent.
The water inlet filter is clogged.
The loading door is not closed.
The drain hose may be clogged or twisted.
The pump filter is clogged.
The machine is not in balance.
A hard substance has entered the
pump filter.
The transport safety screws have
not been removed.
The amount of laundry in the machine
is too low.
The machine is overloaded.
The machine is resting on a rigid object.
The drain hose may be clogged or twisted.
The pump filter is clogged.
The washing machine has stopped
temporarily due to low voltage.
The height of the drain hose is not
appropriate.
The water is in the invisible part of the
device.
Solution
• Press the Start/Pause/Cancel
button.
• Reduce the amount of laundry and
make sure the loading door is
properly closed.
• To cancel the programme, use the
program selector to choose another
programme. The previous program
will be cancelled. (See "Program
Cancellation" section)
• This is not a problem and does not affect
your machine in any way.
• Open the taps.
• Straighten the pipe.
• Cleaning the filter.
• Close the door.
• Clean or straighten the pipe.
• Cleaning the pump filter.
• Balance the machine by adjusting the feet.
• Cleaning the pump filter.
• Remove the transportation safety
screws.
• Add laundry to the machine.
• Remove a quantity of laundry
from the machine or distribute it
manually in order to balance it
evenly in the machine.
• Make sure that the machine is not placed
on any object.
• Clean or straighten the pipe.
• Cleaning the pump filter.
• It can resume operation when the
voltage returns to the normal
level.
• Connect the water drain hose
as indicated in the user
manual.
• This is not a problem.
Washing machine / User manual