Advertisement
Available languages
Available languages
• Setup the device in a dry location where it is pro-
tected against splashing water.
• Do not install the device in a dusty environment.
• Make sure that the mounting surface is capable
of supporting the weight of the device.
• Use ductwork or cable ducts if it is necessary to
lay cables through metal panels or other panels
with sharp edges.
• Do not lay the cable so that it is loose or heavily
kinked.
• Fasten the cables securely.
• Do not pull on the cables.
• Lay the cables so that they cannot be damaged
by the doors or the bonnet. Crushed cables can
lead to serious injury.
Scope of delivery
Quantity Description
1
D+ Active Simulator
2
Cable tie
1
Installation and Operating Manual
Target group
The electrical installation and setup of
the device must be performed by a qual-
ified electrician who has demonstrated
skill and knowledge related to the con-
struction and operation of electrical
equipment and installations, and who is
familiar with the applicable regulations
of the country in which the equipment is
to be installed and/or used, and has
received safety training to identify and
avoid the hazards involved.
All other actions are intended also for non-profes-
sional users.
Intended use
The device is intended to simulate the D+ signal in
vehicles where is no longer possible to pick up
from the alternator, for example Euro-6 vehicles.
This product is only suitable for the intended pur-
pose and application in accordance with these
instructions.
This manual provides information that is necessary
for proper installation and/or operation of the
product. Poor installation and/or improper operat-
ing or maintenance will result in unsatisfactory per-
formance and a possible failure.
The manufacturer accepts no liability for any injury
or damage to the product resulting from:
• Incorrect assembly or connection, including
excess voltage
• Incorrect maintenance or use of spare parts
other than original spare parts provided by the
manufacturer
• Alterations to the product without express per-
mission from the manufacturer
• Use for purposes other than those described in
this manual
Dometic reserves the right to change product
appearance and product specifications.
Technical description
The D+ signal is necessary to activate various addi-
tional devices (e.g. battery separator relay, AES
refrigerator, charging booster). The device is trig-
gered by the engine vibration. When the engine
stops, the switching output turns off automatically.
Functions:
• Switching output (D+ signal) overload pro-
tected and short circuit proof (max 0.3 A)
• Switch on delay 4 s
• Adjustable switch off delay
• Voltage detection
• Suitable for 12 V or 24 V system
Installing the device
!
WARNING! Electrocution hazard
The installation may only be carried out
by a qualified electrician.
The device is attached directly to the engine with
cable ties and triggered by the engine vibration.
4445103616
5
Advertisement
Chapters
