Toro ProCore 648s Operator's Manual page 45

Figure 89
1. Aerate bail
Raising the Coring Head
Delay-Drop Mode
Use the front tire (Figure
when in delay-drop mode.
Figure 90
To raise the core head, perform 1 of the following:
•
As the front tire rolls over the perimeter of aeration
area, release the aerate bail
Note:
The machine delays lifting the coring head
until the coring head reaches the targeted spot
you identified using the front tire and released the
aerate bail.
90) to sight the raise point
(Figure 91).
g342253
1. Aerate bail
•
Drive the machine in the reverse direction; refer
to Driving the Machine in the Reverse Direction
(page 46).
Aerating Using the
Immediate-Drop Mode
1. Press the bottom of the drop-control switch
(Figure 92) to the I
Note:
The light in the switch illuminates.
g381161
1. Drop-control switch
2. Drive the machine in the forward direction; refer
to Driving the Machine in the Aerating Mode
(page 43).
3. Close either the left or right the aerate bail
(Figure 93).
Note:
The coring head immediately lowers and
begins aerating.
45
Figure 91
-D position.
MMEDIATE ROP
Figure 92
g342257
g343438