Toro ProCore 648s Operator's Manual page 30

Note:
Do not tighten the flange locknuts.
Figure 38
1. Washer (7/16 x 13/16 inch) 4. Turf guard
2. Flange locknut (3/8 inch)
3. Turf guard clamp
Assembling the Tine Holder
1. Loosely assemble the tine clamp to the tine
holder (Figure 39) with 4 bolts (3/8 x 1-1/2
inches). Do not tighten the bolts.
Note:
The bolts are parts in the tine holder kits.
Figure 39
1. Tine holder
2. Tine clamp
2. Assemble the tines into the tine holder and tine
clamp (Figure 40).
g357675
5. Stud (turf-guard bracket)
g356449
3. Bolt (3/8 x 1-1/2 inches)
1. Tine
3. Torque the bolts (3/8 x 1-1/2 inches) securing
the tine clamps and tines to 40.6 N∙m (30 ft-lb).
4. Repeat steps
clamps, tine holders, and tines.
Assembling the Tines to the
Coring Head
1. Loosely assemble tine holder and tines to tine
arm #2 (Figure 41
(1/2 x 1-1/4 inches).
1. Number 5 tine holder
30
Figure 40
2. Bolt (3/8 x 1-1/2 inches)
1 through 3 for the other tine
and Figure 42) with 3 bolts
Figure 41
2. Number 2 tine holder
g356451
g357676