Toro ProCore 648s Operator's Manual page 23

Settings
Menu Item
Units
Language
LCD Backlight
LCD Contrast
Protected Menus
Protect Settings
Max Speed
indicates the menu item is accessed by entering the PIN.
About
Menu Item
Model
SN
Machine Controller Revision
InfoCenter Revision
CAN Bus
indicates the menu item is accessed by entering the PIN.
Diagnostics
Menu Item
Engine Run
PTO
Traction
Protected Menus
There are 3 protected operating settings within
the Settings Menu of the InfoCenter: Max Speed,
Area 2—Area, Area 2—Volume. These settings are
unlocked by using the
(page 23) procedure.
Note:
At the time of delivery, your distributor may
have changed the PIN code.
Description
Controls the units used on the
InfoCenter (English or metric)
Controls the language used
on the InfoCenter*
Controls the brightness of the
LCD display
Controls the contrast of the
LCD display
Allows an authorized person
with the PIN code to access
protected menus
Allows the ability to change
the settings in the protected
settings
Allows the ability to change
the maximum forward ground
speed—default = 6.4 kph (4
mph)
Description
Lists the model number of the
machine
Lists the serial number of the
machine
Lists the software revision of
the master controller
Lists the software revision of
the InfoCenter
Lists the machine
communication bus status
Description
Refer to the Service Manual
or your authorized Toro
distributor for more information
on the Engine Run menu and
the information contained
there.
Accessing Protected Menus
Accessing Protected Menus
Note:
The factory default PIN code for you machine
is either 0000 or 1234.
If you changed the PIN code and forgot the code,
contact your authorized Toro distributor for assistance.
1. From the M
AIN
scroll down to the S
right button (Figure
2. In the S
ETTINGS
scroll down to the P
the right button
3. To enter the PIN code, press the center button
until the correct first digit appears, then press
the right button to move on to the next digit
(Figure 27B and
until the last digit is entered and press the right
button once more.
23
M , use the center button to
ENU
M and press the
ETTINGS ENU
26).
Figure 26
M , use the center button to
ENU
M and press
ROTECTED ENU
(Figure 27A).
Figure 27
Figure 27C). Repeat this step
g028523
g028522