Toro ProCore 648s Operator's Manual page 13

Assembling the Brake Cable
1. Route the fitting of the brake cable under the
bottom of the handle-bar channel
1. Handle-bar channel
2. Brake-cable fitting
3. Washer (5/16 inch)
2. Assemble the brake-cable fitting on to the clevis
pin, and secure the fitting to the pin with the
washer and hairpin.
Connecting the Wire Harness
1. Route the 6-pin connector and the 12-pin
connector of the machine wire harness through
the grommet in the handle-bar channel
7).
(Figure
Figure 6
4. Clevis pin
5. Hairpin
(Figure
6).
1. 6-pin connector (machine
wire harness)
2. Plug the 12-pin connector of the machine
harness into the 12-socket connector of the
handlebar wire harness
g358118
1. 12-socket connector
(handle wire harness)
2. 6-socket connector
(handle wire harness)
3. Plug the 6-pin connector of the machine harness
into the 6-socket connector of the handlebar
harness.
4. Insert the push-in anchor of the machine
harness into the hole in the handle-bar channel
(Figure
13
Figure 7
2. 12-pin connector (machine
wire harness)
(Figure
Figure 8
3. 6-pin connector (machine
wire harness)
4. 12-pin connector (machine
wire harness)
9).
g358122
8).
g358121