Toro ProCore 648s Operator's Manual page 14

Figure 9
1. Push-in anchor
2. Handle-bar channel
5. Insert the push-in anchor of the machine
harness into the hole in the guide bracket.
6. Secure the machine harness to the handle-bar
channel with a cable tie through the slots in the
channel (Figure 10).
g358123
3. Guide bracket
1. Slot (handle-bar channel)
2. Cable tie
7. Secure the machine harness to the guide
bracket with a cable tie through the slots in the
bracket.
Installing the Handlebar Cover
1. Align the small notch in the handlebar cover with
the notch up (Figure
1. Thread-forming screw
(1/4 inch)
2. Handle-bar channel
14
Figure 10
3. Slot (guide bracket)
11).
Figure 11
3. Small notch (handle-bar
cover)
g372270
g358120