Figure 83
4.
Look in the direction of your planned path to
ensure that it is clear.
5.
Grasp the left or right handlebar and the
operator-presence bail
the bail to the handle.
6.
With you thumb, rotate the left or right traction
control to drive the machine as follows:
•
Rotate the top of the traction control forward
to drive the machine forward.
•
Rotate the top of the traction control rearward
to drive the machine backward.
Note:
Further rotating the traction control
increases the groundspeed of the machine.
Stopping the Machine
Important:
To immediately stop the machine
press the bump-stop switch
Figure 84
1. Bump-stop switch
1.
If you are aerating, release the aerate bail
(Figure
85) to raise the coring head; refer to
Raising the Coring Head (page
g343435
(Figure
82), and squeeze
(Figure
84).
g339547
46).
1. Operator-presence bail
2. Aerate bail
2.
Release the traction control, and allow it to move
to the N
EUTRAL
3.
Release the operator-presence bail.
4.
Fully raise and latch the handlebar to engage
the parking brake; refer to
Brake (page
39).
Driving the Machine in the Aerating
Mode
Note:
The machine drives at a reduced variable
speed anytime the coring head is raised.
1.
Start the engine, and move the throttle control
to the F
position; refer to
AST
(page
40).
2.
Lower the handlebar to release the parking
brake; refer to
(page
39).
3.
Press the right side of the transport/aeration
switch to the A
43
Figure 85
3. Traction control
position.
Engaging Parking
Starting the Engine
Releasing the Parking Brake
position
(Figure
ERATE
g339607
86).