Connect To An Ethernet Network; How To Connect To Virtual Private Networks - Honeywell CT40 User Manual

1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings
3. Tap Wi-Fi preferences. The Configure Wi-Fi menu appears.
4. Tap the Open Network notification to toggle the setting on or off.

Connect to an Ethernet Network

To connect the computer to an Ethernet network, you need an CT40 Ethernet
Home Base or CT40 Net Base.
1. Make sure the base is connected to your Ethernet network.
2. Place the computer in the base.
3. Swipe up from the bottom of the Home screen to access all apps.
4. Tap Settings
5. Tap Ethernet.
6. (Optional) To assign a static IP address.
7. Tap Save.

How to Connect to Virtual Private Networks

The computer supports connecting to virtual private networks (VPNs). This section
describes how to add and connect to VPNs. To configure VPN access, you must
obtain details from your network administrator. You view and change VPN settings
in the Settings app.
Note: Before you can add or connect to a VPN network, you must enable a screen lock
method.
72
> Network & Internet. > Wi-Fi Verify the Wi-Fi radio is turned
on.
> Network & Internet > Ethernet. The Ethernet setting is
turned On by default.
The Ethernet connection screen shows the current Ethernet connection. By
default, the computer assumes a DHCP connection, and that your network has
assigned an IP address automatically. If DHCP is working, the Ethernet base
should indicate that communication with the network is occurring.
a. Tap DHCP and then select Static from the list.
b. Enter the required network information, and then tap Apply.
CT40/CT40 XP Mobile Computer Series User Guide