Kia Seltos Manual page 364

Maintenance
manufacturer's instructions. Wax all
metal trim to protect it and to
maintain its luster.
Removing oil, tar, and similar mate -
rials with a spot remover will usually
strip the wax from the finish. Be
sure to re-wax these areas even if
the rest of the vehicle does not yet
need waxing.
Be careful not to touch the lens
when waxing the lamps.
CAUTION
Drying vehicle
Wiping dust or dirt off the body
with a dry cloth will scratch the
finish.
Do not use steel wool, abrasive
cleaners, acid detergents or
strong detergents containing high
alkaline or caustic agents on
chrome-plated or anodized alu -
minium parts. This may result in
damage to the protective coating
and cause discoloration or paint
deterioration.
Finish damage repair
Deep scratches or stone chips in the
painted surface must be repaired
promptly. Exposed metal will quickly
rust and may develop into a major
repair expense.
8 98
NOTICE
If your vehicle is damaged and
requires any metal repair or
replacement, be sure the body shop
applies anti-corrosion materials to
the parts repaired or replaced.
Bright-metal maintenance
To remove road tar and insects, use
a tar remover, not a scraper or
other sharp object.
To protect the surfaces of bright
metal parts from corrosion, apply a
coating of wax or chrome preserva -
tive and rub to a high luster.
During winter weather or in coastal
areas, cover the bright metal parts
with a heavier coating of wax or
preservative. If necessary, coat the
parts with non-corrosive petroleum
jelly or other protective compound.
Underbody maintenance
Corrosive materials used for ice and
snow removal and dust control may
collect on the underbody. If these
materials are not removed, acceler -
ated rusting can occur on under -
body parts such as the fuel lines,
frame, floor pan and exhaust sys -
tem, even though they have been
treated with rust protection.
Thoroughly flush the vehicle under -
body and wheel openings with luke -
Appearance care