Kia Seltos Manual page 348

Maintenance
Rear fog lamp (Bulb type) bulb
replacement (if equipped)
OSP2I079182L
1. Disconnect the negative (-) bat -
tery terminal.
2. Disconnect the rear fog lamp con -
nector.
3. Remove the socket from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on
the assembly.
4. Remove the bulb from the socket
by pressing it in and rotating it
counter-clockwise until the tabs
on the bulb align with the slots in
the socket. Pull the bulb out of
the socket.
5. Insert a new bulb by inserting it
into the socket and rotating it
until it locks into place.
6. Install the socket into the assem -
bly by aligning the tabs on the
socket with the slots in the
assembly. Push the socket into
the assembly and turn the socket
clockwise.
8 82
7. Connect the rear fog lamp con -
nector.
Replacing headlamp (high and low)
/ position lamp / daytime running
lamp / turn signal lamp (LED type)
(headlamp type C)
If the position lamp / daytime run -
ning lamp LED (1) does not operate,
we recommend that the system be
checked by a professional workshop.
Kia recommends to visit an autho -
rised Kia dealer/service partner.
OSP2079039
The LED lamps cannot be replaced
as a single component because it is
an integrated unit. The LED lamps
have to be replaced with the unit.
A skilled technician should check or
repair the position lamp / daytime
running lamp (LED), for it may dam -
age related parts of the vehicle.
Replacing headlamp (high and low) /
position lamp / daytime running
lamp / turn signal lamp (LED type)
(headlamp type C)
Light bulbs