Kia Seltos Manual page 243

Hide thumbs Also See for Seltos:
Table of Contents

Advertisement

What to do in an emergency
rosive. When jump starting, wear
protective glasses and be careful
not to get acid on yourself, your
clothing or on the vehicle.
Do not attempt to jump start the
vehicle if the discharged battery is
frozen or if the electrolyte level is
low; the battery may rupture or
explode.
Do not allow the (+) and (-)
jumper cables to touch. It may
cause sparks.
The battery may rupture or
explode when you jump start with
a low or frozen battery.
Jump starting procedure
1. Make sure the booster battery is
12-volt and that its negative ter -
minal is grounded.
If the booster battery is in
another vehicle, do not allow the
vehicles come in contact.
2. Turn off all unnecessary electrical
loads.
3. Open the engine bonnet and
remove the service cover on the
front passenger seat side in the
engine compartment.
4. Remove the fuse box cover on the
front passenger seat side in the
engine compartment
5. Open the positive terminal cap
inside the engine room fuse box
and the negative terminal cap
close to the vehicle body.
6. Connect the jumper cables in the
exact sequence shown in the illus -
tration.
1)Connect one end of a jumper
cable to the positive terminal of
the discharged battery (1).
2)Connect the other end to the
positive terminal of the booster
battery (2).
3)Proceed to connect one end of
the other jumper cable to the
negative terminal of the
booster battery (3), then the
other end to a solid, stationary,
metallic point (for example, the
engine lifting bracket) away
from the battery (4). Do not
connect it to or near any part
that moves when the engine is
cranked.
Do not allow the jumper cables
to contact anything except the
correct battery terminals or the
correct ground. Do not lean
over the battery when making
connections.
CAUTION
Battery cables
Do not connect the jumper cable
from the negative terminal of the
booster battery to the negative ter -
minal of the discharged battery.
This can cause the discharged bat -
tery to overheat and crack, releas -
ing battery acid.
Make sure to connect one end of the
jumper cable to the negative termi -
nal of the booster battery, and the
Emergency starting
7
7
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents