Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
C. Floor/Double Stack -16"
Countertop Legs
1. Turn the oven over onto its left side so you can
easily reach the bolt mounting locations base.
2. Using the four corner most holes in the bottom of
the oven insert and tighten the four countertop
legs.
3. Carefully turn the oven upright. Insure the two
legs that touch the floor first when you raise the
oven are blocked so they do not slip away.
Floor Installation
1. At the floor end of each leg install the bullet foot
insert or caster as required. The fit of the insert
to the leg is intended to be snug, you should
expect to tap them lightly in place with a mallet
or rubber hammer. Using your fingers screw the
ends of the bullet feet into the leg clockwise
until they are at their shortest length. Or
Casters mount to the bottom of the caster plate
with four each: 3/8-16 bolts inserted into a split
ring lock washer and flat washer.
2. Turn the oven over onto its left side so you can
easily reach the bolt mounting locations in the
base.
3. The three holes in the top of each leg will match
the bolt locations at each corner of the oven
base.
4. You will need three 3/8-16 hex head bolts and
three 3/8" flat washers to mount each leg. Align
COUNTERTOP ELECTRIC PIZZA OVEN OPERATION MANUAL
the leg to one of the matching bolt holes on the
base and inset a bolt and washer. Install the
other bolts and finger tighten into place before
using a wrench to fully tighten them all.
5. Be sure to tighten all bolts for each leg. When
installing casters, make sure the two casters
with brakes are installed at the front of the oven
and the restraining plate is inserted between
the right rear leg and the oven base as shown.
6. Carefully stand up the oven. Insure the two
legs/casters that touch the floor first when you
raise the oven are blocked and chocked so they
do not slip away.
7. Attach the Warning label for the restraining
device on the face of one of the front legs as
shown.
8. Provide a suitable restraining chain or cable to
securely tether the appliance to the building
structure. The restraining chain or cable should
be of such length, that it will stop movement of
the appliance before there is any strain on the
power supply cable.
Optional Open Base Feature:
1. Install bottom shelf and rack guide brackets
when installing legs -while oven is on it's
side. Refer to leg instructions in Installation/
Operation Manual.
2. Attach two rack support brackets to base of
4
Advertisement
Table of Contents
