Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
oven with three screws each bracket.
3. Install two legs to lower (left) side of oven. Align
and attach bottom shelf to these legs with a bolt
and locking nut -One each in the front and back.
4. Attach last two legs.
5. Attach bottom shelf to remaining two legs with
two bolts and locking nuts - One each in the
front and back.
6. When the oven is stood up, before moving it to
it's final location, install four remaining bolts
and locking nuts to the legs -Two on left side,
two on right side. Tighten all.
7. Install two rack guides. Align the bottom pegs
WARNING
Risk of electrical shock. Appliance must be
secured to building structure.
to holes in the bottom shelf. Align top hooks to
cut- outs in upper support bracket. Lower into
position.
8. Align oven racks (order separately) to the shelf
heights desired and slide into place.
Electrical Connections
COUNTERTOP ELECTRIC PIZZA OVEN OPERATION MANUAL
5
Double Stacked Ovens
Your EP-1-2828 or EP-2-2828 may be
stacked two ovens on top of one another.
In order to ensure the ovens do not slide
or separate, there is a stacking bracket kit
required for installation at the rear of the
ovens. Two brackets are installed, one at
each end of the oven securing the upper
oven to the bottom oven. Refer to the
adjacent illustration.
1. Installation must be performed by licensed
electrician.
2. A separate electrical connection to the mains
must be provided for each oven.
3. An all pole disconnect must be provided by the
installer.
4. Connection to the electrical service must be
grounded in accordance with local codes. In
the absence of local codes refer to the National
Electric Code, ANSI/NFPA 70 or the Canadian
Electric Code, CSAC22.2 as applicable.
5. Only bare copper conductors with a minimum
insulation temperature rating of 90°C to be
used.
6. The installer must supply a properly sized strain
relief bushing for the mains connection that
meets
7. The oven shall be installed using flexible
conduit.
8. The restraint cord must be securely attached to
the rear of the oven and to the building structure
to prevent transmitting unnecessary stress to
the flexible conduit.
CAUTION
Disconnect all ovens from electrical supply
before servicing. Connection is accessed by
removing the right side cover. Field connections
are located at the lower rear corner of the
control compartment.
Advertisement
Table of Contents
