Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Usage Recommendations
1. Pre-heat the oven thoroughly before use. Allow
one hour and fifteen minutes for pre-heat.
2. Pre-heat ovens @ 75°F (24°C) BELOW desired
cook/bake temperature.
3. Do not move baking location in the middle of a
bake, but spinning is okay.
4. Keep decks clean of flour, cheese, etc using a
deck/scraper brush.
5. During idle periods, reduce heat by 75°F (24°C).
6. Minimize water content of products for faster
cook/bake times.
7. For larger & thick products, reduce temperature &
increase bake/cook time.
8. Cooking times and temperatures will vary
depending upon such factors as size of the load,
temperature, mixture of products (particularly
moisture) and density of products.
Troubleshooting
There are no user serviceable components behind the covers. Contact your service agent.
Problem
Indicator light is out
Set temperature has been reached.
The top and bottom heat control switches
are "OFF".
Power supply fuses or circuit breakers are
blown or have been tripped.
No power
Power supply fuses or circuit breakers are
blown or have been tripped.
No power to oven.
High temperature thermostat tripped.
Oven too hot
Thermostat set too high.
Thermostat may be defective.
Bottom of pies are
If the same area of the deck is used
Undercooked
repeatedly, the deck temperature in that area
will be reduced.
Bottom switch set too low.
Top switch set too high.
Bottom of pies burn
Deck temperature too hot - especially during
before toppings are
slow periods
cooked
Bottom switch set too high.
Top switch set too low.
Pies cook unevenly
Areas adjacent to oven walls are generally
hotter.
Element defective
Heat selector switch faulty
COUNTERTOP ELECTRIC PIZZA OVEN OPERATION MANUAL
Probable Cause
9. Keep a record of the times, temperature and load
sizes you establish for various products. Once
you have determined these, they will be similar
for succeeding loads.
10. When practical, start cooking the lowest
temperature product first and gradually work up
to the higher temperatures.
11. When loading the oven, work as quickly as
possible to prevent loss of heat.
12. Oven will continue to heat even though the timer
goes off. Product should be removed from the
oven as soon as possible to avoid overcooking.
13. When baking, weigh or measure the product in
each pan to assure even cooking.
14. Only bread and pizza may be placed directly on a
stone baking hearth.
Take no action. The thermostat has turned off the power to the
heat switches, indicator and heating elements. When oven starts
to cool, all functions will be restored
Turn switches to a position other than "OFF". This will allow
indicator lamps, contactors and heating elements to operate
Replace fuse or reset circuit breaker.
Replace fuse or reset circuit breaker.
Check supply voltage.
Reset and check oven for fault condition.
Lower the thermostat setting. Allow several hours for heat to
regulate
Call local authorized Bakers Pride service agent.
Rotate pies to unused areas of the bake deck that are hotter and
will cook the bottoms faster.
Increase setting.
Decrease setting.
Reduce Thermostat setting by 50°-75° below normal bake
temperature. When decks cool begin cooking and immediately
increase the thermostat setting by 50° - 75°.
Decrease setting.
Increase setting.
Rotate pies (180°), once during each bake or keep to the center
of oven.
Replace element
Replace heat selector switch
7
Remedy
Advertisement
Table of Contents
