Remote Control Operation - Sea Breeze PTAC Service Manual

Remote Control Operation

Note:

When power is connected (stand by condition), operate the air conditioner with the remote control.

Indoor controller will beep each time it receives a command from the remote control, and the sending
signal icon displayed on the remote control.

It shows the set temperature on the remote control.
ON/OFF -Turns the unit on or off. There is a 3 minute compressor delay when the unit is turned on.
MODE – Pressing the MODE button will select between AUTO, COOL, DRY, FAN, or HEAT.

AUTO mode - Unit will operate automatically according to ex-factory setting; the set temperature cannot
be changed. The fan speed can be changed by pressing the FAN button in this mode.

COOL mode - Unit cools room to set point temperature.

DRY mode - FAN runs in LOW speed only. (FAN speed cannot be changed).

FAN mode - Selects fan only operation. Set point temperature can be changed. Fan speed can be set
to HIGH, LOW or AUTO.

HEAT mode - Unit heats room to set point temperature.
+ / - Raises or Lowers the set point temperature – The set temperature will increase or decrease 1°F by
each pressing. Holding the button down for more than 2 seconds will cause the set point to auto increment
or decrement. This does not function in the AUTO mode since the temperature set point cannot be changed.
FAN – Press this button to change fan speeds, HIGH, LOW or AUTO, while in the HEAT, COOL, FAN
modes. When in the AUTO setting, the fan will run faster the further away from the set point it gets. On the
other hand, the closer it gets to the set point the slower it will run. FAN speed cannot be changed in Dry
mode.
SWING – Pressing the SWING button will start and stop the louver moving up and down.
SLEEP – In the COOL, Heat and Dry mode press the SLEEP button to active the function. Press the
SLEEP mode button to toggle SLEEP mode off and return to normal operation.
The SLEEP mode does not work in the FAN or AUTO modes and is deactivated when the unit is turned off
or power is lost. On power up, the SLEEP mode must be turned on again if needed.
TIMER – Press this button when the unit is ON, the autostop function will stop the unit in the current mode.
The unit will turn off when the selected time is reached. T-OFF and H icons will be blinking after the TIMER
button pressed. Press "+" or "-" button to adjust the time value in five seconds. Each press will increase or
decrease 0.5 hour. Holding the button down for more than 2 seconds will cause the set point to auto
increment or decrement. Release this button after your required set time is reached. Press this button again
for confirming. T-OFF and H icons will then stop blinking.
- Press this button when the unit is OFF, the autostart function will turn the unit on in the previous mode.
The unit will turn on when the selected time is reached. T-ON and H icons will be blinking after the
TIMER button pressed. Press "+" or "-" button to adjust the time value in five seconds. Each press will
increase or decrease 0.5 hour. Holding the button down for more than 2 seconds will cause the set
point to auto increment or decrement. Release this button after your required set time is reached. Press
this button again for confirming. T-ON and H icons will then stop blinking.
- Review and Cancel Timer function: If TIMER function is activated, press TIMER button once to review
the remaining time, and cancel this function by pressing the button again in 5 minutes.
~21~