Sea Breeze PTAC Service Manual page 14

INSTALL UNIT INTO WALL SLEEVE
1. Carefully remove shipping tape from the front panel and vet door. See Fig.5.
2. Remove shipping screw from the vent door, if present. See Fig.6.
3. Remove front panel. See Fig.7.
4. Lift unit level and slide unit into wall sleeve until foam seal rests firmly against front of wall sleeve.
5. Secure with four screws (supplied) through the unit flange holes. See Fig.8.
6. Reinstall front panel. See Fig.9.
CAUTION
UNIT DAMAGE HAZARD
Failure to follow this caution may result in equipment
damage or improper operation.
Failure to remove shipping tape and screw will prevent
fresh air vent door from opening and may result in
damage to vent door cable.
Shipping
tape
Fig.5. – Shipping Tape Location
Fig.6. – Shipping Screw Location
Remove shipping
screw if present
~12~
Pull out at the bottom to release it from the tabs (1).
Then lift up (2).
Fig.7. – Removing Front Panel
Fig.7. – Removing Front Panel
Fig.8. – Securing Unit
Place tabs over top rail (1). Push inward at bottom
until panel snaps into place (2).
Fig.9. – Replacing Front Panel