Sea Breeze PTAC Service Manual page 13

RETROFIT SLEEVE PREPARATION
IMPORTANT: Inspect wall sleeve thoroughly prior to installation. Manufacturer does not assume
responsibility for costs or damages due to defects in sleeve or for improper installation.
WARNING
ELECTRICAL SHOCK HAZARD
Failure to follow this warning could result in personal injury
or death.
Disconnect all power to unit to avoid possible electrical
shock during installation.
Remove any existing foam baffles that are installed on competitive outdoor grille, if present. See Fig.1
GE Sleeves Only
GE Metal Wall Sleeve - Remove metal clip on mounting rail located on left, inside bottom, of metal sleeve and
discard. See Fig. 2.
GE Plastic Sleeve - Remove bottom seal from plastic sleeve. See Fig. 3.
INSTALLATION OF A CARRIER WALL SLEEVE USING A NON CARRIER GRILLE
This application has become more common due to pre-manufactured windows with built-in grilles or renovations
where a Carrier sleeve is used with an existing non-Carrier grille.
Use of a Carrier wall sleeve with a non-Carrier grille requires installation of an Accessory Baffle Kit (see Fig. 4),
which ensures a good seal between the unit and exterior grille to prevent air recirculation. Air recirculation is a
large contributor to performance loss and premature damage to major components.
BAFFLES
Fig. 1 - Remove Existing Outdoor Grille Baffles on
Competitive Grille
Fig. 3 - Remove Bottom Seal From GE Plastic Sleeve
Fig. 4 - Accessory Baffle Kit
Note: Contact with your unit supplier to get the kit and
it may be different from the shape shown above.
~11~