Safety Instructions; Parameter Access Levels; Target Audience - ABB ACS880 Firmware Manual

16 Introduction to the manual

Safety instructions

Follow all safety instructions delivered with the drive.
• Read the complete safety instructions before you install, commission, or use
the drive. The complete safety instructions are delivered with the drive as either
part of the Hardware manual, or, in the case of ACS880 multidrives, as a separate
document.
• Read the firmware function-specific warnings and notes before changing
parameter values. These warnings and notes are included in the parameter
descriptions presented in chapter Parameters.

Parameter access levels

The parameters in the Winch control program are visible based on the two access
levels: Short menu and Long menu.
Short menu (pass code 1) – Lists the most common winch parameters. This is the
default menu when the drive is powered up for the first time. See parameter
Pass code.
Long menu (pass code 584) – Lists the complete signals and parameters in the
control program. These parameters are visible only when you set parameter
Pass code = 584.
See also the short menu parameters list marked in the chapter
data on page 569.
Note: It is recommended that you create the backup of complete parameters list
using the long menu. However, you can also access the complete parameters list in
the offline mode.

Target audience

This manual is intended for people who design, commission, or operate the drive
system.
96.02
96.02
Additional parameter