ATEN CS1182DP4C User Manual page 32

ATEN Secure KVM User Manual
LED
Power LED
(on the Secure KVM switch)
Video LED
(on the Secure KVM switch)
Port LED
(on the Secure KVM switch
and the RPS)
CAC LED
(on the Secure KVM switch
and the RPS)
CAC models only
The Power LED is on the front panel and lights green to indicate that
the KVM switch is powered on.
The Video LED is located on the back panel next to each video
connector.
The LED lights green when the video connection is up and
running.
The LED flashes when a non-qualified monitor is connected.
The Port LEDs are located on the front panel (of the switch) and the
upper-left side of each pushbutton (of the RPS) to indicate the port
selection or connection status.
Online – Lights dim orange to indicate that the computer attached
to its corresponding port connected and powered on.
Selected – Lights bright orange to indicate that the computer
attached to its corresponding port has the KVM focus.
Warning - Flashes to indicate that a non-qualified USB HID device
is connected to console USB keyboard port or mouse port when the
corresponding port has the focus.
Note:
1. Port and CAC LEDs will flash constantly when a chassis
intrusion is detected. See Chassis Intrusion Detection section for
details.
2. Port and CAC LEDs (on the Secure KVM switch) also indicate
the status of the Secure KVM self-test status. See Operation
section for further details.
The CAC LEDs are located on the front panel (of the switch) and the
far right of the upper bar on the panel (of the RPS) to indicate CAC
reader selection or connection status.
Online – Lights dim green to indicate that the computer attached
to its corresponding port has a USB CAC reader cable connection
and the CAC function is enabled.
Selected – Lights bright green to indicate that the CAC function is
enabled and the computer attached to its corresponding port has the
CAC focus.
None – No lights indicate that the cable is not connected or CAC
has been disabled.
Warning - Flashes to indicate that a non-qualified USB Smart card
/ CAC reader is connected when the corresponding port has the
focus.
Note:
- The CAC function of each port can be enabled or disabled by
Indication
21