ATEN CS1182DP4C User Manual page 19

ATEN Secure KVM User Manual
No. Component
Port Selection
1
Pushbuttons
2 Port and CAC LEDs
3 Reset Button
Pressing a Port Selection Pushbutton brings together the keyboard,
mouse, video, audio, and CAC reader focus to the computer attached
to its corresponding port.
The Port / CAC LEDs are located on front panel to indicate Port/CAC
reader selection or connection status.
Port LEDs (Lower row; Orange LEDs)
Online – Lights dim orange to indicate that the computer attached to
its corresponding port is connected and powered on.
Selected – Lights bright orange to indicate that the computer
attached to its corresponding port has the KVM focus.
Warning - Flashes to indicate that a non-qualified USB HID device is
connected to console USB keyboard port or mouse port when the
corresponding port has the focus.
CAC LEDs (Upper row, Green LEDs, CAC models only)
Online – Lights dim green to indicate that the computer attached to
its corresponding port has a USB CAC reader cable connection and
the CAC function is enabled.
Selected – Lights bright green to indicate that the CAC function is
enabled and the computer attached to its corresponding port has the
CAC focus.
None – No lights indicate that the cable is not connected or CAC has
been disabled.
Warning - Flashes to indicate that a non-qualified USB smart card /
CAC reader is connected when the corresponding port has the focus.
Note:
1. CAC function of each port can be enabled or disabled by pressing
the port selection pushbutton for more than 3 seconds (this is a
toggle feature). Please refer to the Operation section of this user
manual for more information.
2. All front panel LEDs (except the Power LED) will flash
continuously when a chassis intrusion or self-test failure (except
for Pushbutton jam) is detected. See Chassis Intrusion Detection
section for further details.
3. Port and CAC LEDs also indicate the status of the Secure KVM
self-test status. See Operation section for further details
Press this button to reset the ATEN Secure KVM Switch.
Note:
When you perform a reset by pressing the reset button for more than 5
seconds, the keyboard/mouse buffer will be purged and the switch will
reboot and perform a self-test. After a successful self-test, port focus
will be switched to port 1, and the CAC function of each port will be set
Description
8