Table of Contents
Advertisement
ATEN Secure KVM User Manual
Plug your console monitor(s) into the console video port(s) located on the unit's rear panel and
2.
power on the monitor.
Note:
1.
When the ATEN Secure KVM Switch is powered on, the Video LED lights green when the
video connection is up and running. The Video LED flashes when a non-qualified monitor is
connected.
2.
Due to the security policy, the ATEN Secure KVM Switch does not support a monitor hot-swap.
If you would like to change the console monitor, you must first power off the entire installation.
3.
Connected monitors will be filtered when the ATEN Secure KVM Switch is powered on.
Non-qualified monitors will be rejected (Video LED flashes). Please refer to the LED Display
for detailed visual identification.
Plug your speakers into the console's speaker jack located on the unit's front panel.
3.
Note:
Only speaker connections are allowed. The use of an analogue microphone or line-in audio
connection is strictly prohibited.
4.
With a single-display Secure KVM Switch, using a KVM cable set (not supplied with this package
and must be purchased separately), plug the video connector into any available video socket in the
KVM port section of the switch, then plug the accompanying USB (keyboard/mouse or CAC) and
speaker connectors into their corresponding USB and speaker ports.
With a dual-display Secure KVM Switch, using a KVM cable set (not supplied with this package
and must be purchased separately), plug the video connector for your primary monitor into any
available video socket A in the KVM port section of the switch. Using another video cable and
plug the video connector for your secondary monitor into video socket B on the same KVM port
section of the switch, then plug the accompanying USB (Keyboard/Mouse or CAC) and speaker
connectors into their corresponding USB and speaker sockets.
.
Note:
1.
Verify that all the plugs are in the same KVM port sockets (all in Port 1, all in Port 2, etc.). Each
socket is marked with an appropriate icon.
2.
If the CAC reader function is to be disabled for certain PCs, it's advised not to connect a USB
CAC cable in the installation.
5.
At the other end of the KVM cable set, plug the USB, video, and speaker cables into their
respective ports on the computer.
With a dual-display Secure KVM Switch, at the other end of the other video cable, plug this video
cable into its respective port on the computer.
16
Advertisement
Table of Contents
