General Pipe Cleaners Speedrooter 92 Operating Instructions Manual page 8

®
Speedrooter 92
HOW TO INSTALL DRUM
DISCONNECT MACHINE FROM POWER SOURCE
BEFORE INSTALLING DRUM!
1. To install the inner drum, pull approximately 12 inches of cable
from the drum. Grease the inner drum bushing. Slide the cable
through the hole in the inner drum as shown in Figure 2. Slide
the inner drum onto the drum hub bushing.
Figure 2
2. Lay the machine frame on its side and roll the drum, with inner
drum installed, between the front post and drum shaft. Be sure
the front of the drum is facing the front post.
3. While standing behind the frame, line the drum shaft up with the
hole in the back of drum, slightly lift the frame, and slide the drum
shaft into the back of the drum until the drum contacts the thrust
washer on the shaft. Make sure the needle roller bearings inside
the hub of the drum stay in place.
4. Make sure that the three washers are still on the drum retaining
bolt and thread the bolt into the drum shaft, just finger tight.
5. Stand the machine upright, then tighten the retaining bolt with a
3/4" socket with extension.
6. Slide the V-Belt over the drum (64" for large drum; 59" for small
drum) and hang it from the motor pulley (or slip clutch). Push
down on the motor enough to slide the V-Belt onto the drum.
7. Pull about 12" of cable out beyond the front post.
8. Slide the Flexitube, spring end first, onto the cable and into the
inner drum. (See Figure 3)
Figure 3
9. Then guide the knurled portion of the Flexitube spring into the
front post clamp. (See photo)
10. With one hand on the cable
in front of the front post,
push the cable down to
secure the Flexitube in
position within the clamp.
Make sure the hole in the
Flexitube seats properly
over the guide pin in the
base of the clamp.
11. Then close the clamp and
tighten the knob with your
other hand.
12. Slide the Power Cable Feed over the cable and align the bolt
with the hole in the front post and the guide pins with the holes
on the clamp. When flush with the front post, secure with knob
and washer behind the front post.
13. Slide the belt guard over the stud on top of the motor and tighten
the knob.
DISCONNECT MACHINE FROM POWER SOURCE
BEFORE PERFORMING MAINTENANCE!
8