Operation - Ferm PSM1033 Original Instructions Manual

The following charger of the can be used to
charge these batteries.
CDA1168 Charger adapter
CDA1170 Quick charger
The batteries of the FX-POWER 20V battery
platform are interchangeable with all the FERM
FX-POWER battery platform tools.
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with
a standardised test given in EN 62841; it may be
used to compare one tool with another and as a
preliminary assessment of exposure to vibration
when using the tool for the applications mentioned:
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
Description
The numbers in the text refer to the diagrams on
page 2-3.
1. On/off switch
2. Grip
3. Dust bag
4. Sanding pad
5. Sanding paper
6. Dust extraction port
7. Rubber ring
8. Battery (not included)
9. Battery unlock button
3. ASSEMBLY
Connecting the dust bag (Fig. B)
It is highly recommended to use the machine with
the dust bag (3), ensuring optimal dust collection.
• Slide the dust bag (3) onto the dust extraction
port (6) using a slight twisting motion.
• Keep sliding in twisting motion until the dust
bag (3) is positioned slightly over the rubber
ring (7), fixing it in place.
Note: The dust bag should be emptied when the
bag is half full to maintain optimal dust collection.
Mounting and removing sanding paper (Fig. C)
• Hold the machine on its side or upside down,
as shown on Fig. C1.
• Mount sanding paper (5) with the required
grain size onto the sanding pad (4). Make
sure that the perforation in the sanding paper
(5) corresponds with the perforation on the
sanding pad (4), as shown on Fig. C2.
• To remove the sanding paper (5), simply pull
the sanding paper from the sanding pad (4).
Note: Use coarse sanding paper for sanding
rough, uneven surfaces. Use medium sanding
paper for removing the remaining scratches from
the coarse sanding paper. Use fine sanding paper
for finishing surfaces.
Before any work on the power tool,
remove the battery.
The battery must be charged before first
use.
Inserting the battery into the machine (Fig. D)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (8) into the base of the
machine as shown in Fig. D.
2. Push the battery further forward until it clicks
into place.
Removing the battery from the machine (Fig. D)
1. Push the battery unlock button (9).
2. Pull the battery out of the machine like shown
in Fig. D.

4. OPERATION

Switching on and off (Fig. A)
• To switch on the machine, press the on/off
switch (1) into position I.
• To switch off the machine, press the on/off
switch (1) into position 0.
7