Machine Information - Ferm PSM1033 Original Instructions Manual

Shorting the battery terminals together may
cause burns or a fire.
d) Under abusive conditions, liquid may be
ejected from the battery; avoid contact.
If contact accidentally occurs, flush with
water. If liquid contacts eyes, additionally
seek medical help. Liquid ejected from the
battery may cause irritation or burns.
e) Do not use a battery pack or tool that is
damaged or modified. Damaged or modified
batteries may exhibit unpredictable behaviour
resulting in fire, explosion or risk of injury.
f) Do not expose a battery pack or tool to
fire or excessive temperature. Exposure to
fire or temperature above 130 °C may cause
explosion. NOTE The temperature „130 °C"
can be replaced by the temperature „265 °F".
g) Follow all charging instructions and do not
charge the battery pack or tool outside
the temperature range specified in the
instructions. Charging improperly or at
temperatures outside the specified range may
damage the battery and increase the risk of fire.
6) Service
a) Have your power tool serviced by a
qualified repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
b) Never service damaged battery packs.
Service of battery packs should only be
performed by the manufacturer or authorized
service providers.
Additional safety instructions
• Do not use oversized sanding sheets, but
follow the manufacturer's specifications for
the size of sanding sheets. Sanding sheets
which project over the sanding pad may cause
injuries as well as block and rip the sanding
sheets or cause a kickback.
• It is not recommended to sand lead paint. Lead
paint should be removed by a specialist only.
• Do not work on materials which release
hazardous substances (e.g. asbestos). Take
precautions if hazardous, combustible or
explosive dust is likely to occur. Wear protective
dust mask. Use dust extraction system.
• Do not work materials containing asbestos.
Asbestos is considered carcinogenic.
• Do not use the machine for sanding
6
magnesium workpieces.
• Wear safety goggles. Wear hearing protection.
If necessary, use other protective means, such
as safety gloves, safety shoes, etc.
• Hold the machine by the insulated gripping
surfaces where the accessory may contact
hidden wiring or the mains cable. If the
accessory contacts a ‚live' wire, the exposed
metal parts of the machine can also become
‚live'. Risk of electric shock.
• Be very careful when sanding painted surfaces.
• Before use, remove all nails and other metal
objects from the workpiece.
• Make sure that the workpiece is properly
supported or fixed.
• Only use sanding paper that is suitable for use
with the machine.
• Only use sanding paper with the correct
dimensions. Make sure that the sanding paper
is properly mounted.
• Inspect the sanding paper before each use.
Do not use sanding paper that is worn because
of prolonged use.
• Never put the machine down on a table or a
workbench before it has been switched off.

2. MACHINE INFORMATION

Intended use
The machine is designed for sanding wood,
plastics and metal. This machine is suitable only
for dry sanding. The machine is not suitable for
processing objects containing asbestos. Improper
use may damage the tool.
Technical specifications
Model No.
Voltage
No-load speed
Sanding pad dimensions
Weight
Sound pressure level L
PA
Acoustic power level L
WA
Vibration
Only use the following batteries of the FX-POWER
20V battery platform. Using any other batteries
could cause serious injury or damage the tool.
CDA1167 20V, 2Ah Lithium-Ion
CDA1168 20V, 4Ah Lithium-Ion
PSM1033
20V
10.000/min
150x150x100 mm
0.68 kg
80.2dB(A) K=3dB(A)
91.2dB(A) K=3dB(A)
11.776m/s² K=1.5m/s²