How To Config Tao 1Pro As A Ndi Decoder; How To Config Tao 1Pro As A Player - RGBlink TAO 1pro User Manual

3.1.2 How to Config TAO 1pro as a NDI Decoder

If you need to operate NDI decoding mode, you need to set the IP address (same as IP of camera ), subnet mask and
gateway in [Network Settings] of [Scroll Area] first. Then long press the icon to enter the following interface, turn on
the switch to start NDI decoding function.
Resolution: up to 1920x1080@60
Bitrate: 41000HZ
NDI Type: show NDI type
OFF/ON: turn on/off NDI decoding mode
Note: Please refer to 3.2.1.2 Network for operations of setting IP address,subnet mask and gateway.

3.1.3 How to Config TAO 1pro as a Player

You can insert a USB flash drive into the USB 2.0 port and then play the video in the USB. Long press the icon to
enter the [Player] interface and select the video you want to play.
Note: If there is no USB flash drive inserted, the icon displays gray status.
© Xiamen RGBlink Science & Technology Co., Ltd.
14
Ph: +86 0592 5771197 | support@rgblink.com | www.rgblink.com