Table of Contents
Advertisement
COUNT
In COUNT mode, MIB-1 counts the number of banknotes
(qty) without identifying denomination or valuation of banknotes
in a stack. During counting of banknotes, MIB-1 device will stop
if a banknote is found to be suspicious or unfit to be in circulation.
Operator to remove that banknote and press
counting. It is noted that counting speed can be set to as high as
1500 banknotes, however, it is recommended to count banknotes
at 1200 notes per minute for widely circulated banknotes.
During and once counting is completed, MIB-1 displays total counted quantity on the display screen.
If [ADD] function is turned on, the counted quantity for the current stack is added to the running total
and save into device memory. Note that, key is used to select [COUNT] mode, continue to press
[MODE] key until [COUNT] appears on the display screen in the sequence below:
Counting Results and Display Content
When counting is completed, the LCD display will show the
below information:
Amount and Quantity – Total Value and number of
banknotes counted for the selected currency.
Detail View – Detail view contains quantity, and dollar amount
of counted banknotes by each denomination of banknotes counted as well as total count
if ADD function is activated.
To view detail counting results, press the
screen.
Press the
In case of MULTI-Currency type is selected and operator places mixture of US and Canadian currency
as standard (Options for other world-currencies if purchased and loaded into the device), device will
count both currencies in a single-pass, however, during counting, only QTY will be displayed.
Page | 18
MIX SINGLE S-FACE S-ORNT SORT
COUNT
key to clear the current results and prepare the device for next count.
to resume
key and detail counting results will show on the
Advertisement
Table of Contents
