Counting Speed; Selecting Currency, Auto And Multi-Currency; Single Currency - Amrotec MIB-1 Operator's Manual

 Counting Speed
The device is defaulted from factory to count circulated banknotes at high-speed (about 1000
MIB-1
banknotes per minute), however, software allows user to adjust counting speed to count banknotes at
even higher or lower speed if necessary.
To adjust the counting speed in various Discriminating Modes (MIX / SINGLE / SORT etc) and
'COUNT' mode:
 Press
any discriminating modes or COUNT mode.
 Three different counting speeds can be set for all discriminating modes
(MIX/SINGLE/SORT/FACE/ORIENT), however, 1000 speed is default except for SORT mode
(800 notes / min) and best speed for higher recognition and less jamming.
 Under Discriminating modes
 800 notes / minutes (SORT mode)
 1000 notes / minutes
 1200 notes / minutes
 Under counting (COUNT) mode
 800 notes / minutes.
 1000 notes / minutes.
 1200 notes / minutes
 1500 notes / minutes
 Selecting Currency, Auto and MULTI-Currency:
Currency Discriminator is capable of counting and
MIB-1
denominating of single currency or mixture of world-currencies (USA
and Canada Standard) in a single-pass. To Select one of the installed
currencies (USA and Canada Standard) or choose AUTO (first
currency inserted and counted) or choose Multi-currencies to process
in mixture. Default currency installed will be shown at the very top left
corner of the display screen.
Press the key to see all installed currencies in a separate screen and in sequence with respective
numbers. Arrow  will point to the current currency software.

Single Currency:

 Default currency (USD) installed will be shown at the very top
left corner of the display screen and device will process all
genuine banknotes and halts when a banknote cannot be read
due to being unfit or simply strange or suspect. User to remove
that banknote, either to recount or to perform Manual Entry
function (See Page 14 ~15) to add to current count if found to be genuine and good bill.
Page | 8
key on the left side of the control panel to switch between various speed settings in