Table of Contents
Advertisement
Add mode
ADD feature is used to accumulate piece and value counting results for continuous stacks of banknote
processing application.
Press the
deactivate ADD feature.
When ADD mode is turned on, ADD text will appear on the
second column as highlighted. When ADD is activated,
counting results of different straps are accumulated
automatically.
Auto / Manual Start Mode
To operate the MIB-1 device with Automatic start or manual start, follow the steps below:
Press the
The LCD shows the actual status of the mode on the very right of the second column.
Auto start
MIB-1
the hopper.
Manual start
MIB-1
Auto-Print:
This feature is reserved for trained operator or service professional. Auto-Print feature allows operators
to activate automatic print of receipt (counting results) to an external printer (only to our recommended
printer) once counting is completed and banknotes are completely removed from the Hopper area.
Hopper area must be empty before Auto-Print feature to be functional and will automatically
print to a connected printer.
Page | 11
Once all denominations batches are selected, press
Stop key to save all the newly set denomination batch qty to device
memory. The preset batch number for any denomination should not
exceed the stacker maximum pocket capacity of 200pc.
If operator prefers normal batch under SINGLE and SORT
mode, press
where operator can choose normal Batch or stay with DB setting.
key on the control panel to activate or
key to switch between Auto/Manual Start Mode.
(Auto Start Mode), the
device counts after detecting banknotes on
(Manual Start Mode), the
device counts only after pressing the
key.
BATCH /3 Key to reach to a separate screen
Start/
Advertisement
Table of Contents
